Mount the indoor unit at least 7 ft above the floor. Other common mistakes: a long pipe run, an outdoor unit in sun, no vacuum, a flat drain pipe and no earthing. Each one has a sign you can check yourself.
A typical case we see: a new 1.5 ton inverter AC runs all day and cools the room slowly. The bill is higher than with the old AC. The AC is fine. Two or three fitting mistakes are doing the damage.
This page lists the mistakes and the sign that gives each one away. For the correct method, step by step, read the AC installation checklist.
Mistake 1: The indoor unit is below 7 ft
Cold air sinks. If the indoor unit sits at 5 or 6 ft, the cold air stays near the unit. The sensor reads that cold air and the compressor slows down. Warm air stays near the ceiling and in the far corner.
How to spot it: measure from the floor to the bottom of the indoor unit. Under 7 ft is too low. You also feel cold near the AC and warm at the other end of the room.
Fix: move the unit up to 7 to 8 ft. The same pipes can often be used. Expect ₹1,500 to ₹3,000 with wall patching.
Mistake 2: The pipe run is too long
The installer puts the outdoor unit where it is easy to reach, not where it is close. Every extra foot of pipe means more gas, more joints and some loss of cooling. Past about 25 ft, the AC needs extra gas.
How to spot it: check the bill for extra pipe. More than 15 ft on a simple bedroom job is worth asking about.
Mistake 3: The outdoor unit sits in direct sun
In May, a west-facing wall in Ahmedabad bakes in the afternoon sun. The outdoor unit has to throw heat into air that is already over 45°C. The compressor works harder and the bill goes up.
How to spot it: touch the top of the outdoor unit at 4 pm. If it is too hot to keep your hand on, it needs shade.
Fix: a canopy 2 to 3 ft above the unit with open sides. Do not cover the fan.
Mistake 4: The outdoor unit has no room to breathe
A closed balcony corner, a grille right in front of the fan, or stored boxes. The hot air comes straight back into the unit.
How to spot it: you need 18 to 24 inches clear in front of the fan and 6 to 12 inches at the sides.
Mistake 5: No vacuum before the gas was released
Air and moisture stay in the pipes. Moisture mixes with the oil and damages the compressor over 2 to 3 years. Some installers still "purge" with the AC's own gas instead.
How to spot it: you cannot see this later. Ask on fitting day. If no vacuum pump came out of the bag, it was not done.
Mistake 6: Bad flares and no leak test
A rushed flare leaks slowly. The AC cools well for 3 to 6 months, then gets weak.
How to spot it: oily marks on the pipe nuts at the indoor or outdoor unit. Weak cooling in the first year with no other fault.
Mistake 7: A flat or blocked drain pipe
Water needs a slope. A flat pipe holds water, and the tray overflows down the wall. Standing water in the tray also grows mould.
How to spot it: water drips from the indoor unit, or the wall below it gets damp stains.
Mistake 8: Thin wire, shared circuit or no earthing
The AC runs on an old 1.5 sq mm wire shared with lights. The MCB trips on hot afternoons. Without earthing, a fault can give a shock or burn the PCB. Brands can reject a warranty claim for this.
How to spot it: lights dim when the compressor starts. The plug or socket feels warm. Ask an electrician to check the earth.
Mistake 9: Loose or unsupported pipes
Pipes that hang between clamps shake with the outdoor unit. Over time a joint can crack and leak.
How to spot it: the pipe moves when you push it, or there is no clamp for more than 4 ft.
What these mistakes cost
Take a 1.5 ton 3-star inverter AC at about 1.3 units an hour, 8 hours a day and ₹6 a unit. That is about ₹1,900 a month in summer. Sun on the outdoor unit and a low indoor unit together can add 15% to 20%.
| Mistake | Typical fix cost |
|---|---|
| Indoor unit too low | ₹1,500 to ₹3,000 |
| Outdoor unit in sun | ₹1,500 to ₹2,500 for a canopy |
| Flare leak | ₹2,500 to ₹4,500 with gas refill |
| Drain pipe slope | ₹300 to ₹800 |
| Own circuit, MCB and earthing | ₹1,500 to ₹3,000 |
| Move outdoor unit with new pipe | Labour plus ₹220 to ₹320 per ft of pipe |
Your electricity cost will differ. Check it with the AC electricity cost calculator.
If your AC shows two or more of these signs, book a check from our AC service team. We tell you which fixes are worth doing and which are not.
Common questions
What is the 7-foot rule for AC installation?
Mount the split AC indoor unit at least 7 ft above the floor. Cold air sinks, so a high unit cools the whole room. A low unit cools the air near itself and switches off early.
Why is my new AC not cooling well after installation?
The common causes are a gas leak at a bad flare or no vacuum before the gas was released. An outdoor unit in direct sun or a closed corner also cuts cooling. A technician can check the gas pressure and joints in 20 minutes.
How far can the outdoor unit be from the indoor unit?
Keep the pipe run at 15 ft or less if you can. Past about 25 ft, the AC needs extra gas and loses some cooling. Never go beyond the maximum length in the brand manual.
Can a badly installed AC be fixed without buying a new one?
Yes. Most mistakes can be fixed by re-fitting the same AC. Moving the indoor unit higher costs about ₹1,500 to ₹3,000. Moving the outdoor unit costs more if new pipes are needed.
Service and repair team
Want a second opinion?
Send us your question on WhatsApp. A technician replies, not a bot.
We reply in about 15 minutes, Mon to Sat, 9 AM to 7 PM.
Read next
AC Buying Guide for Indian Homes: Size, Star Rating, Cost
Which AC to buy in 2026? Pick the ton by room size, choose inverter and star rating, and plan ₹43,000 to ₹66,000 for a 1.5 ton AC with fitting.
How Much Ton AC for My Room? Size Chart 10x12 to 20x20
A 10x12 room needs a 1 or 1.5 ton AC, 12x12 needs 1.5 ton, 12x15 needs 2 ton. Full room size to tonnage chart for Indian summers, with sun and floor rules.
AC Installation Best Practices: Step-by-Step Checklist
How a split AC should be installed, in 6 stages: indoor unit at 7 to 8 ft, copper pipes, vacuum, earthing and a 30-minute test. Use it on fitting day.