Monsoon AC guide for Gujarat: settings, care and power safety

Updated 19 October 2026 · 5 min read · By the System Designing service team

In the Gujarat monsoon, use Dry mode at 25 to 26°C with the fan on Low or Auto, and keep windows closed. Wash the filter every 2 weeks and check the drain pipe. Protect the AC from voltage spikes with a stabilizer, and switch it off in storms.

In May, Ahmedabad is 44°C and dry. In July and August, it is 30 to 34°C, but humidity goes up to 70% or more. Sweat does not dry, so 32°C feels worse than 40°C.

Many people then set the AC to 18 or 20°C. The room gets cold but still feels damp, and the bill goes up. The fix is a different mode, not a lower number.

Monsoon humidity in Gujarat cities

CityTypical monsoon humidityWhat it means for your AC
Ahmedabad, Gandhinagar65% to 75%Dry mode on most rainy days
Vadodara, Rajkot70% to 80%Dry mode, filter wash every 2 weeks
Surat, Valsad, Bharuch75% to 90%Dry mode most days, filter wash every 10 days

The right settings for humid days

  1. Select Dry mode. The icon is usually a water drop.
  2. Set 25 to 26°C.
  3. Set fan speed Low or Auto. Slow air lets the coil pull out more water.
  4. Close windows and doors. Outside air brings the moisture back.
  5. Run the AC for a longer stretch, not short on-off bursts.

Each degree below 24°C adds about 6% to the bill. At 20°C instead of 26°C, you pay about 35% more and the room still feels damp. On a hot, sunny monsoon day, Cool mode at 24 to 25°C is fine.

Monsoon care for the AC

Filter

Wash the indoor filter every 2 weeks from June to September. In Surat and other coastal towns, wash it every 10 days. A damp dusty filter grows mould fast.

Drain pipe

In the monsoon, the AC removes more water than in summer. Pour a mug of water into the indoor tray once a month. It should drain out in about 30 seconds. If it backs up, clear the pipe end or call a technician.

Smell

A musty smell means mould on the coil. Run Fan mode for 10 minutes before you switch off each night. This dries the coil. If the smell stays after a filter wash, book a wet service.

Outdoor unit

Rain does not harm the outdoor unit. It is built to stand in the open. Do not wrap it in plastic while it runs, because it needs free airflow. Remove wet leaves and plastic bags that collect on the coil after a storm.

Service dates

  • Early June: a full service before the rain starts.
  • October: a wet service to clean out mould from the monsoon.

Protect the AC from voltage swings

Storms, tripping lines and power cuts cause voltage spikes. These damage the PCB, which costs ₹3,000 to ₹8,000 to replace.

  • Switch off the AC at the MCB during thunder and lightning.
  • After a power cut, wait 3 to 5 minutes before you switch the AC on.
  • Use a stabilizer if your voltage often falls below 200 V or goes above 250 V.
  • Check that the outdoor unit stand is above flood level and the unit sits level.

Not sure if you need a stabilizer? Our AC stabilizer calculator tells you the kVA and voltage range for your AC.

Common monsoon problems

  • Water drips from the indoor unit: usually a blocked drain pipe.
  • AC trips after a storm: check the MCB, then look up any code on our AC error code page.
  • Room cold but damp: you are in Cool mode at a low setting. Switch to Dry mode.

For step-by-step fixes, see common AC problems and quick fixes. If a problem keeps coming back, read the AC warning signs or book a visit through our AC repair service.

Common questions

Which AC mode is best in the monsoon?

Dry mode at 25 to 26°C on humid days. It removes moisture with less power than Cool mode at a low setting. Use Cool mode on hot, sunny monsoon days.

Why does my room feel sticky even when the AC shows 24°C?

The air still holds a lot of moisture. Close windows, set fan speed Low or Auto, and switch to Dry mode so the coil can pull the moisture out.

Do I need a stabilizer for my AC in the monsoon?

If your voltage drops below 200 V or jumps above 250 V, yes. Many inverter ACs work from about 150 V to 260 V, but storms and power cuts cause spikes outside that range.

When should I service my AC around the monsoon?

Once in early June before the rain, and once in October after it. The October wet service removes the mould that grows in a humid season.

Service and repair team

Want a second opinion?

Send us your question on WhatsApp. A technician replies, not a bot.

We reply in about 15 minutes, Mon to Sat, 9 AM to 7 PM.